List Of How Deep To Cut Groove For Drawer Bottom References. Position the drawer bottom back in place (push it into the grooves). Cutting the dovetail tails and.
Cut Grooves into Drawer Face Step One House Home from housebecominghome.com
Use a straight bit (what ever size your bottom thickness is) to cut the. I am not much of a dado blade guy, (takes to. Get about eye level with your board.
7) Be Sure To Select.
The final design has a 31/64 wide x 3/16 deep dado all around the 5/8 bb sides to receive the 1/2 bb bottom. Layout the distance from the edge and width of the groove with a. Make sure the face of the router is flat.
I Need A Little Advice On Cutting Groves For Floating Drawer Bottoms.
The dado for a 1/2″ thick bottom is only 3/8″, therefore the dado must be made 3/8″ wide and 5/8″ up from the bottom. It probably would be easier with a router table and the right router b. Clamp the box as shown;
This Drawer Is Almost Ready To Assemble.
Use a straight bit (what ever size your bottom thickness is) to cut the. Route the handles on the cutting board. Secure and check the wood.
Since The Dado We’re Cutting Is A Little Less Than 3/4 In.
In a nutshell, here is how to make the groove: The maximum dado size to accept any bottom is 3/8″. I typically start the groove 1/4″ from the bottom of each board.
Check That The Edge For The Fence Is Smooth And Straight.
The bottom is cut with a total of 1/32 clearance in width and depth. Remove the spacer, and butt the fence against the stop block. Drawer length x drawer height;
Share this post
0 Response to "How Deep to Cut Groove for Drawer Bottom"
0 Response to "How Deep to Cut Groove for Drawer Bottom"
Post a Comment